Section 4 - Operation; Controls - Miller Electric 172 M-10 Gun Owner's Manual

4-1. Controls

SECTION 4 – OPERATION
1 Wire Speed Control
1
Use control to select a wire feed
speed. As Voltage switch setting in-
creases, wire speed range also in-
creases (see weld setting label in
welding power source).
2 Voltage Switch
2
.
Switch must "click" into detent
position 1, 2, 3, or 4 for proper
contact.
3 The higher the selected number,
the thicker the material that can be
welded (see weld setting label in
welding power source). Do not
switch under load.
3 Voltage Switch - Fan Only
Position
In Fan Only position, fan runs but
there is no weld output.
4 4 Power Switch
Ref. ST-187 921
OM-1318 Page 17