Quick Reference Guide; Sub-Compact Stove Installation - Dimplex CS-1205 Owner's Manual

Quick Reference Guide

1. Prior to the first use of the
Sub-Compact Stove verify the
following:
• Are the circuit breakers for the
unit on?
• Are the light bulbs in your
Sub-Compact Stove loose? (to
check, follow the instructions
for replacing the light bulbs
under the Maintenance section
of this manual)
2. The heater on your Sub-Com-

Sub-Compact Stove Installation

!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or blows
fuses on a regular basis when
the heater is operating. Addi-
tional appliances on the same
circuit may exceed the current
rating of the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord
is stored or secured to avoid
tripping or snagging to reduce
the risk of fire, electric shock or
6
pact Stove may emit a slight,
harmless odor when first
used. This odor is a normal
condition caused by the initial
heating of internal heater
parts and will not occur again.
3. If you have any technical
questions or concerns regard-
ing the operation of your Sub-
Compact Stove, or require
service contact Customer
Service at 1-888-346-7539
before returning the product
to the point of purchase.
injury to persons.
Construction and electrical
wiring must comply with local
building codes and other appli-
cable regulations to reduce the
risk of fire, electric shock and
injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons, al-
ways use a licensed electrician.
Installation
① Make sure the unit's Main On/
Off Switch is switched Off (refer to
operating instruction section).
② Plug the unit into a 15 Amp,
120 VAC outlet.
www.dimplex.com