Programming An Interface For An Access Point; Keyboard Wedge; Laptop Direct Connect; Rs232 Serial Port - Honeywell Voyager 1602g User Manual

Programming an Interface for an Access Point

If you are using a Honeywell Access Point (AP01-XXXBT) to communicate with the VG1602, you can use the following bar
codes to program the Access Point interface. These bar codes set the Access Point for commonly used interfaces.

Keyboard Wedge

If you want your system programmed for an IBM PC AT and compatibles keyboard wedge interface with a USA keyboard,
scan the bar code below, then power cycle the host. Keyboard wedge is the default interface. This interface is only appro-
priate for an Access Point.
Note: The following bar code also programs a carriage return (CR) suffix.

Laptop Direct Connect

For most laptops, scanning the Laptop Direct Connect bar code allows operation of the scanner in parallel with the inte-
gral keyboard. The following Laptop Direct Connect bar code also programs a carriage return (CR) suffix and turns on
Emulate External Keyboard
ate for an Access Point.

RS232 Serial Port

The RS232 Interface bar code is used when connecting to the serial port of a PC or terminal. The following RS232 Inter-
face bar code also programs a carriage return (CR) and a line feed (LF) suffix, baud rate, and data format as indicated
below. It also changes the trigger mode to manual. This interface is only appropriate for an Access Point.
2 - 12
IBM PC AT and Compatibles with
(page 2-9). Power cycle the host after scanning this bar code. This interface is only appropri-
Laptop Direct Connect
Option Setting
Baud Rate 115,200 bps
Data Format 8 data bits, no parity bit, 1 stop bit
CR suffix
with CR suffix
RS232 Interface