Menu Bar Code Security Settings; Setting Custom Defaults - Honeywell Voyager 1602g User Manual

Press the scan button to project an aiming beam. This beam should be centered over the bar code, but it can be positioned in
any direction for a good read.
The aiming beam is smaller when the scanner is closer to the code and larger when it is farther from the code. Symbologies
with smaller bars or elements (mil size) should be read closer to the scanner. Symbologies with larger bars or elements (mil
size) should be read farther from the scanner. To read single or multiple symbols (on a page or on an object), hold the scanner
at an appropriate distance from the target, press the scan button, and center the aiming beam on the symbol. If the code being
scanned is highly reflective (e.g., laminated), it may be necessary to tilt the code up 15° to 18° to prevent unwanted reflection.

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending serial commands to the scanner. If you want
to restrict the ability to scan menu codes, you can use the Menu Bar Code Security settings. Contact the nearest technical sup-
port office (see Technical Assistance

Setting Custom Defaults

You have the ability to create a set of menu commands as your own, custom defaults. To do so, scan the Set Custom Defaults
bar code below before scanning the menu commands for your custom defaults. If a menu command requires scanning numeric
codes from the back cover, then a Save code, that entire sequence will be saved to your custom defaults. When you have
entered all the commands you want to save for your custom defaults, scan the Save Custom Defaults bar code.
Set Custom Defaults
Note: The Custom Defaults settings apply to all workgroups Scanning the Save Defaults bar code also causes both the
scanner and the host to perform a reset and become unlinked. You must relink (pair) the scanner to the host. See
Wireless System Operation
Linear bar codes
with aiming beam
on page -ix) for further information.
beginning on page 3-1 for additional information.
2D Matrix symbol
with aiming beam
Save Custom Defaults
1 - 5