Playing A Bluetooth Device; Searching And Playing Tracks - Sony RSX-GS9 Operating Instructions Manual

To remove the device
Stop playback, then remove the device.
To display the sampling frequency and bit
depth of the audio file being played
Press DSPL during playback.
For example, the information appears as follows:
[192/24]: 192 kHz/24 bit
[DSD 5.6MHz]: 5.6 MHz/1 bit
Notes
 Gapless playback is performed when the sampling
frequency and bit depth are identical to those of the
next or previous track.
 If the displayed sampling frequency and bit depth are
not appropriate, check the settings of the device and
its connection.
 For a DSD file on the device connected via the USB
micro-B port, native DSD playback is performed.
During playback, make sure that the native DSD
playback on the High-Resolution USB Audio
supported device performs properly.
Corresponding data interface, sampling frequency
and bit depth:
 PCM:
Max. 192 kHz/24 bit
 DSD:
ASIO Native: 2.8 MHz/1 bit, 5.6 MHz/1 bit
DoP: 2.8 MHz/1 bit, 5.6 MHz/1 bit

Playing a BLUETOOTH Device

You can play contents on a connected device that
supports BLUETOOTH A2DP (Advanced Audio
Distribution Profile). Using an LDAC-supported
device is recommended.
1
Make BLUETOOTH connection with the
audio device (page 9).
2
Press SRC to select [BT Audio].
Alternatively, press SOURCE on the remote
commander.
3
Operate the audio device to start
playback.
4
Adjust the volume on this unit.
Notes
 Even if the source is changed on this unit, playback of
the audio device does not stop.
 [BT Audio] does not appear in the display while
running the "SongPal" application via the BLUETOOTH
function.
14
GB
To match the volume level of the BLUETOOTH
device to other sources
Start playback of the BLUETOOTH audio device at a
moderate volume, and set your usual listening
volume on the unit.
Press and hold MENU, then select [BT Setting] 
[BTA Level] (page 18).
To apply the SBC codec only
Press and hold MENU on the remote commander,
then set [Audio Codec] in [BT Setting] to [SBC]
(page 18).

Searching and Playing Tracks

Use the remote commander to perform the
following.
For the iPod, repeat play and shuffle play are not
available.
Repeat play and shuffle play
1
During USB1 or USB2 playback, press REP
or SHUF repeatedly to select the desired
play mode.
Playback in the selected play mode may take
time to start.
Repeat play mode:
 [Repeat Track] plays the track repeatedly.
 [Repeat Album] plays tracks in the album
(folder) repeatedly.
 [Repeat OFF] cancels repeat play.
Shuffle play mode:
 [Shuffle Device] plays all tracks in the "Music"
folder in random order.
 [Shuffle OFF] cancels shuffle play.
Notes
 During repeat play, shuffle play mode cannot be
selected. During shuffle play, only [Repeat Track]
can be selected, and [Repeat Album] cannot be
selected.
 [Shuffle Device] is only available when repeat play
is off.
 When shuffle play is performed or canceled,
playback starts from the first track in the "Music"
folder.
 While shuffle play is performed with [Repeat
Track] selected, pressing  will cancel [Repeat
Track] and restart shuffle play from the first track
in the "Music" folder.
 During shuffle play, the list display on "SongPal" is
not available. To enable the list display, cancel
shuffle play mode.