Setting The Low Cut Filter; Using The Level Control Function - Tascam DR-22WL Reference Manual

4 – Recording

Setting the Low Cut Filter

The Low Cut Filter function can reduce noise from
air-conditioners, projector fans and unwanted wind noise.
1. Press the RECORD button to set the recording standby
mode.
The RECORD indicator will flash and displays the recording
screen.
2. Press the F4
button to display the input setting screen.
3. Press the F1 button to display the
input setting screen.
4. Use the F2 and F3
item and press the F4
parameter of the
LCF
Open the parameter list for the
5. Use the F2 and F3
cut-off frequency.
Options: (default value),
OFF
220Hz
6. Press the F4
button to finalize the selected cut-off
frequency for the Low Cut Filter.
7. Press the /MENU/8 button to return to the recording
screen.
NOTE
• When the low-cut filter is on, the
recording screen.
• The low-cut filter can be set and changed when in recording
standby.
TIPS
• Setting it to larger value can reduce more noise in the
low-frequency range, but this is not recommended when
recording music.
• The DR-22WL has a built-in reverb, which can be added to
the input source as desired. (See "Reverb function" on page
30.)
18
TASCAM DR-22WL
page of the
INPUT
buttons to select (highlight) the
button.
item.
LCF
buttons to select (highlight) the
, ,
40Hz 80Hz 120Hz
icon appears on the

Using the level control function

You can set the recording level for microphone input.
1. Press the RECORD button to set the recording standby
mode.
The RECORD indicator will flash and displays the recording
screen.
2. Press the F4
3. Press the F1
input setting screen.
4. Use the F2 and F3
parameter of the
button.
Open the parameter list for the
5. Use the F2 and F3
function.
,
Options: (default value),
OFF
6. Press the F4
7. Press the /MENU/8 button to return to the recording
screen.
The selected function is shown with an icon in the recording
screen.
NOTE
The selected mode is shown with an icon in the recording
screen.
• When the limiter function is ON, the
on the recording screen.
• When the peak reduction function is ON, the
will appear on the recording screen.
LIMITER
8
The limiter functions only at excessive input level.
This function is useful for musical instrument performance and
musical recordings.
PEAK (PEAK REDUCTION)
8
This function automatically reduce the recording level to an
appropriate value when input signal is too high. It is useful
when you cannot preset the recording level or unable to make
adjustments during recordings.
CAUTION
Distortion might occur if the input sound is too loud even
when the limiter is on. In such a case, lower the input level
or increase the distance between the mic and the sound
source.
NOTE
When level control function is ON, you can still adjust the
recording level by using the INPUT LEVEL volume. This
function cannot be used, however, when the scene dial is set
to or .
button to display the input setting screen.
button to display the
INPUT
buttons to select (highlight) the
item and press the F4
LV CONTROL
LV CONTROL
buttons to select (highlight) the
,
LIMITER PEAK
button to finalize the selected function.
icon will appear
page of the
item.
icon