Install The Refrigerator - Norcold N41 Series Installation Manual

- For N51X models, if the construction of the vehicle does not allow
the distance [25] to be 47 3/4 inches, the distance (optional only)
can be as little as 44 3/4 inches (See Art01647) if you obey the
instructions that follow:
- Install only 621156 vent as the lower intake vent [9].
- Add two baffles to the rear of the enclosure if there is more than
1 inch of clearance [19] between the rear of the refrigerator
and the enclosure.
- Install one baffle [16] at the top edge of the lower intake
vent.
- Install a bent aluminum or galvanized steel sheet baffle
[26] at the lower edge of the upper exhaust vent opening.
- Make sure that the bend of the baffle is flush with the
lower edge of the upper exhaust vent opening.
- Make sure that the top edge of the bent baffle is 1/4
inch or less [124] below the condenser and that there
is 1/4 inch or less clearance [124] between the rear of
the condenser and the baffle.
- Make sure the baffles are the full width of the inside of
the enclosure.

Install the Refrigerator

Put the refrigerator in position (see Art01288):
Make sure the combustion seal [28] is not broken, is completely
!
WARNING
around the refrigerator mounting flanges [156], and is between
the mounting flanges and the wall of the enclosure. If the
combustion seal is not complete, exhaust fumes can be present
in the living area of the vehicle. The breathing of exhaust fumes
can cause dizziness, nausea, or in extreme cases, death.
- Remove the door from the refrigerator (See "Reverse the door swing" section).
- Put screws through the holes of the refrigerator mounting flanges and into the
enclosure wall.
- Attach the door to the refrigerator.
- Put a screw through the mounting holes [121] in the braces at the lower rear corners of
the refrigerator and into the floor.
13
14
Art01647
121
124
124
24
26
25
16
9
19
28
156
Art01288
Installation Manual 7