Install The Refrigerator - Norcold Polar 7 Series Installation Manual

Install the Refrigerator

Put the refrigerator in position (See Art 02646, Art 02625 and Art 02626):
Make sure the combustion seal [28] is not broken, is completely
!
WARNING
around the refrigerator mounting flanges, and is between the
mounting flanges and the wall of the enclosure. If the seal is not
complete, exhaust fumes can be present in the living area of the
vehicle. The breathing of exhaust fumes can cause dizziness,
nausea, or in extreme cases, death.
NOTICE Do not tilt refrigerator into enclosure as damage to enclosure or refrigerator
could occur.
- Push the refrigerator completely into the enclosure.
- Put screws [41] through the upper mounting bracket of the refrigerator and into the
enclosure wall. Snap plastic trim piece [40] into the upper mounting brackets.
Do not omit the bottom trim piece. This piece is part of the
!
WARNING
combustion seal.
- Push the bottom trim piece [29] onto the front of the refrigerator.
- Put two screws [41] through the bottom trim piece, the mounting flange, and into the floor.
- Put screws through mounting flange on the rear of the refrigerator and into the floor.
41
41
Art 02626
28
Art 02646
40
Art 02625
29
Installation Manual 11