Vent Filter; Installation Instructions - GE PGP989 Owner's Manual And Installation Instructions

PArtS InCluDED (PACKED BEloW tHE CooKtoP)
• Blower assembly
• Blower plenum
• (4) Nuts (10-32 keps – nuts with
lock washers attached)
• (9) Sheet metal screws
(8-18 x 3/8")
• Foam gasket tape (9-ft . roll)
• Vent grille

• Vent filter

Check to be sure that all packing materials
and tape have been removed . This will include
tape on control knobs (if applicable), adhesive
tape, wire ties, cardboard and protective
plastic . Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated .
Burner Grate (2)
CAutIon:
GlASS IS FrAGIlE
Do not BumP EDGE
oF GlASS DurInG
InStAllAtIon
Blower Assembly and (4)
Mounting Nuts (10-32 keps – nuts
with lock washers attached)

Installation Instructions

unPACKInG your CooKtoP
• Vent grille gasket
• Cleaning cream
• Scrub sponge or scraper
(on some models)
• Burner grates
• Burner heads
(1 small (A), 2 medium (B),
1 large (C))
Reflective Tape
Regulator
Burner Caps and Burner Heads
Burner Cap and Burner Head
Foam Gasket Tape
Cleaning Cream
Scrub Sponge
Vent Grille
Vent Grille Gasket
16
• Burner caps
(1 small, 2 medium, 1 large)
• Gas pressure regulator &
LP Conversion Instructions
• Attached 120-volt grounded
plug cord
• Reflective tape
Sheet Metal Screws (9)
(8-18 x 3/8")
CAUTION:
DO NOT LIFT
FROM VENT
OPENING OR
BUMP GLASS
Burner Cap and Burner Head
Blower Plenum
Vent Filter