Specifications - Whistler XP800i Owner's Manual

TROUBLESHOOTING / SPECIFICATIONS
Problem
Equipment has a high start up surge.
Battery voltage below 10 volts.
Inverter is too hot (thermal shutdown
mode).
XP800i WATT INVERTER SPECIFICATIONS
Maximum Continuous Power .................................... 800 Watts
Maximum Surge (Peak Power) .............................. 1600 Watts*
No Load Current Draw ............................................... <0.6 A
Waveform ................................................. Modified Sine Wave
Input Voltage .............................................. 11 – 15.5 +/- .5V
AC Receptacle ...................................... Two North American
Fuses ................................... (3) 35 Amp (Spade Type-Internal)
USB ..................................................................... 5V 2.1A Max
Approximate Dimensions ........... 8.25" L x 5.10" W x 2.55" H
Approximate Weight ................................................... 3.10 lbs
*Under certain conditions your inverter may provide up to 2 times
the continuous rating for a brief period.
Red LED On
Solution
Turn inverter power switch center OFF
(O) and then Inv+USB (l) again until the
inverter powers your appliance. Repeat
as necessary to get your appliance
"started".
Recharge or replace battery.
Allow inverter to cool. Check for
adequate ventilation. Reduce the load
on the inverter to load on the inverter
to output.
20