Asus Motherboard P5V-VM DH User Manual page 66

2.3.5 2.3.5 2.3.5 2.3.5 2.3.5 SATA 1/2 SATA 1/2 SATA 1/2 SATA 1/2 SATA 1/2
While entering Setup, the BIOS automatically detects the presence of Serial
ATA devices. There is a separate sub-menu for each SATA device. Select a
device item then press <Enter> to display the SATA device information.
Main
Extended IDE Drive
Access Mode
Capacity
Cylinder
Head
Landing Zone
Sector
F1:Help
ESC: Exit
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Landing Zone and Sector). These values are not
user-configurable. These items show 0 if no SATA device is installed in the
system.
Extended Drive [Auto] Extended Drive [Auto] Extended Drive [Auto]
Extended Drive [Auto] Extended Drive [Auto]
Selects the type of fixed disk connected to the system.
Configuration options: [None] [Auto]
Access Mode [Auto] Access Mode [Auto]
Access Mode [Auto] Access Mode [Auto] Access Mode [Auto]
Sets the sector addressing mode. Configuration options: [Large] [Auto]
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Capacity Capacity
Capacity Capacity Capacity
Displays the auto-detected hard disk capacity. This item is not
configurable.
Cylinder Cylinder Cylinder
Cylinder Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
2 - 1 8 2 - 1 8
2 - 1 8 2 - 1 8 2 - 1 8
Phoenix-Award BIOS CMOS Setup Utility
SATA 1
[Auto]
[Auto]
0 MB
0
0
0
0
↑↓ ↑↓ ↑↓ : Select Item
↑↓ ↑↓
→← →← →←: Select Menu →← →←
Enter: Select SubMenu
-/+: Change Value
C h a p t e r 2 : B I O S S e t u p C h a p t e r 2 : B I O S S e t u p
C h a p t e r 2 : B I O S S e t u p C h a p t e r 2 : B I O S S e t u p C h a p t e r 2 : B I O S S e t u p
Select Menu
Item Specific Help
Selects the type of fixed
disk connected to the
system.
F5: Setup Defaults
F10: Save and Exit