Stanley RW30110 User Manual page 23

J.SAURON
Coder's pulses defect
Axis engine's cards
Interface card
Couple Engine + Coder.
PROBABLE CAUSE
The PGA
The Roll n' Roll
Cables
Charlie box
Link cable between the TRANSLAMATIC and
the Charlie box
Welding trigger opened (Welding control
connector)
Stabilized alimentation out of service
PROBABLE CAUSE
Ground cable
Interface card
Arc welder generator
FOR ANY INTERNAL INTERVENTION OUT OF THESE POINTS ABOVE,
THANKS TO CALL OUR AFTER SALES DEPARTMENT
TROUBLESHOOTING
TRANSLAMATIC RW30
Check the coder connexion on the right side and
on the bottom of the interface card (J3 connector
side).
Replace the interface card.
Check if the card's lights are alight during a
moving command.
Switch the connexions between the 2 engines and
the recheck the moving of the torch (the
movements are reversed)
Call our After Sales Dpt
Check all the connexions
Check if the card's lights are alight during a
moving command.
Replace the interface card
Call our After Sales Dpt
Replace the couple Engine + Coder.
No wire feeding
Close or set up the wire's pressure with the PGA's
rollers.
Check the wire's drum and/or set the Roll n' Roll
brake
Check the connexions and the PGA's alimentation
cable
Try with another Charlie box
Check if the welding command light is alight on
the interface card
Check the connexions or/and change the cable
Check the closing of the welding trigger with an
ohmeter (value < to 20 ohms) between the pins 3
and 4 of the 7 points connector or C an D of the
Amphenol connector 19 points.
Check the alimentation's tension, normally 27V in
CC.
Call our After Sales Dpt
Wire feeding OK but no welding
Make sure that the ground cable is well connected
Check if the card's lights are alight during a
moving command.
Call our After Sales Dpt
Check the parameters and the good operating of
the arc welder
Call our After Sales Dpt
23
CHECKS AND REMEDYS
CHECKS AND REMEDYS