Table of Contents
Advertisement
SPACING : x.xx mm
WELD.TIME : xxmin
Display of the step between each bead, (distance in mm, 1 mm
equals to 0.04 inch) and estimate welding time in minutes.
-Setting can be made up to 3 shapes:
SETTING SHAPE X ?
NO - VALID
SETTING SHAPE X ?
YES - VALID
Option to repeat the same shape or change the size and
shape as previously indicated.
During welding:
RETURN TORCH TO
INITIAL POINT
Torch moves to starting point of the first bead.
WELDING CYCLE
BEAD xxx/yyy
Shows the bead's number in welding, « xxx », and the to-
tal number of beads of the whole resurfacing of the area,
«yyy».
MOVE TORCH
Torch will moves to retracting point after bead.
VALID TO START
FOLLOWING BEAD
Press VALID key to start the next bead.
END LAYER N : 1
LAYER N : 2 - VAL
If VALID key is pressed, you will have to set anew welding
area. (As previously seen).
OPERATION
If RESET key is pressed:
Allow to place the torch in « Parking » position.
If VALID key is pressed, torch will move to « Parking » posi-
tion.
If RESET key is pressed, back to message:
STOP AND RESTART OF WELDING CYCLE
During the welding, in whatever mode you have selected,
stopping the welding cycle is always possible:
Pressing the RESET key will stop the weld cycle.
To restart the welding cycle, press VALID key.
According to what mode you are using, a correction of the
exact positioning of the torch during the stopping can be
done:
-Maximum correction: 1 cm following the 2 axis « X » and «
Z »
To stop the welding cycle, press the RESET key.
ERROR MESSAGES
During the setting of the points, some errors message can
appear:
Set Position O2:
The distance between points Position O1 and Position O2
must be minimum or equal to 30mm on « X » axis. (This mes-
sage will be displayed only if the distance between Position
O1 and Position O2 < 30mm). Note : this distance (30mm
equals to 1.18 inch) is set in the parameters menu.
20
NEUTRAL POINT ?
TRANSPORT - VALID
HELLO
STOP CYCLE
RESTART CYCLE ?
MIN LEN : 30mm !
LENGTH : xx mm
Advertisement
Table of Contents
