Oven Light - Maytag YMER8775AS User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
The 120-volt appliance outlet located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlet operates independently and is not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop. Damage
to the portable appliance could result if the cooktop is hot.
First try the solutions suggested here or visit our website and reference the Customer Service section to possibly avoid the cost
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Oven will not operate
Oven temperature too high or
too low
Oven indicator lights flash
14

Oven Light

Appliance Outlets
TROUBLESHOOTING
of a service call.
www.maytag.ca
POSSIBLE CAUSES
Power supply cord is unplugged.
ENERGY SAVE is active, and the
display is blank.
Household fuse is blown, or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is not set
correctly.
On ceramic glass models, the
oven control lockout is set.
Cookware is not the proper size.
Control knob set to incorrect heat
level
Range is not level.
Delay start is set.
Control lock is on.
Control is in Demo Mode.
Electronic oven control set
incorrectly
Oven temperature needs
adjustment.
Power to range is turned on or
restored.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
(on some models)
Appliance Outlet Circuit Breaker:
The circuit breaker for the appliance outlet on your range is located
next to the outlet. It is rated for 12 amps.
If the circuit breaker trips, it can be reset by pressing the switch. A
delay of several minutes may be required for the circuit breaker to
cool before it will reset.
SOLUTIONS
Plug into a grounded outlet.
Press any key on the control to display the Time of Day. See the
"Electronic Oven Controls" section for more information.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
See the control lock keypad feature in the "Feature Guide."
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ¹⁄₂" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Timed Cooking" section.
Press and hold START for 3 seconds to unlock.
Press and hold DELAY START for 10 seconds.
See "Electronic Oven Controls" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator lights keep flashing, call for service. See
cover for contact information.