Programming Special Functions - Miele 06 868 521 Operating And Installation Instructions

Every change of the factory setting
should be documented in case of
possible technical service.
Record any changes in the field
"Adjusted value___________".
1. Setting the cold water inlet from:
"Nominal water intake" to "Nominal
water intake + 1 l".
The amount of water taken into the
machine at each intake can be
increased by 1 liter to a maximum of
9.5 liters.
^ Turn the program selector to "STOP".
^ Turn the machine off.
^ Press and hold the "Display" and "Start"
buttons, at the same time turn the
machine on with the "On / Off button".
The displays shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^ Press the "Extra Drying" button once.
"E01" (programming level 1) is
displayed.
^ Turn the program selector to "China &
Crystal".
Either "10" or "11" is displayed.
"10" = Nominal water intake
"11" = Nominal water intake + 1 liter
^ Press "Display" to change from "10" to
"11" or vice versa.
^ Press the "Start" button. "SP" is
displayed.
^ Press the "Start" button again. The
change has been saved.
Value set:

Programming special functions

2. Selecting a second interim rinse
A second interim rinse "Interim rinse II"
can be programmed to improve interim
rinsing in all programs (except for
"Rinse" and "Rapid").
^ Turn the program selector to "STOP".
^ Turn the machine off.
^ Press and hold the "Display" and
"Start" buttons, at the same time turn
the machine on with the "On / Off"
button.
The display shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^ Press the "Extra Drying" button once.
"E01" (programming level 1) is
displayed.
^ Turn the program selector to "Rapid".
"30" or "31" is displayed.
"30" = without interim rinse II
"31" = with interim rinse II.
^ Press "Display" to change from "30" to
"31" or vice versa.
^ Press the "Start" button. "SP" is
displayed.
^ Press the "Start" button again. The
change has been saved.
Value set:
29