Frequently Asked Questions - Miele CS 1028 Operating And Installation Instructions

Frequently asked questions

,
Repairs should only be carries out by an authorized technician in
accordance with local and national safety regulations. Unauthorized repairs
could cause injury or appliance damage. The manufacturer cannot be held
responsible for unauthorized work.
The burner does not ignite after several attempts.
Possible fault
The burner is not assembled correctly.
The gas supply is not turned on.
The burner is dirty.
The flame holes are wet or blocked.
The flame does not stay lit.
Possible fault
During the ignition process, the flame needs to touch the ignition safety control
so that it heats up. If the flames does not touch, check that:
– The burner is seated correctly.
– There is no soiling on the ignition
safety control.
The igniter does not spark.
Possible fault
The circuit breaker has tripped.
Food has deposited itself between the
ignitor and the burner cap.
Food has deposited on the ignition
safety control.
The flame appears different than usual.
Possible fault
The burner is assembled incorrectly.
18
Solution
See "Cleaning and Care -
Reassembling the burner".
Turn on the gas supply.
See "Cleaning and care".
See "Cleaning and care".
Solution
See "Cleaning and Care -
Reassembling the burner".
Solution
Re-set the circuit breaker. Contact an
electrician for assistance if in doubt.
See "Cleaning and care".
See "Cleaning and care".
Solution
Reassemble the burner as shown in
"Cleaning and Care - Burner".