Burner - Miele CS 1028 Operating And Installation Instructions

Burner

Do not clean any parts of the burner
in a dishwasher.
The burner can be dismantled and
cleaned when cool.
^ Remove the burner parts and wash
them in a solution of warm water and
liquid dish soap. Dry them
thoroughly. Make sure that the flame
holes are clean and completely dry.
^ Wipe the burner base clean with a
damp cloth and then dry.
Gently wipe the ignitor and ignition
safety control with a slightly damp
cloth, and then wipe dry.
Do not let the ignitor get wet. If it
gets wet it will not spark.
^ After cleaning dry all surfaces with a
clean cloth.
Cleaning and care
Reassembling the burner
^ Place cover plate
base so that the ignitor and the
ignition safety control extend through
their respective holes in the cover
plate. The cover plate must sit evenly
over the burner base.
Do not use a warped cover plate.
^ Place the burner base in position
above the cover plate making sure
that pins slot into their respective
holes in the burner head
^ Place burner cap
Be careful not to mix up the parts.
over burner
.
in position.
17