Free-Standing Installation - QSC TSC-7t Installation Manual

Free-Standing Installation

1. Perform the steps in "Prepare for Installation (both options)" on page 6.
Refer to Figure 11
2. Remove the Cable Cover (2) from the TSC-7t (1).
Refer to Figure 12
3. Connect the cables to the proper connectors in the TSC-7t
a. LAN A/PoE - required for network. (PoE is optional if you use the 12V DC AUX Power)
b. LAN B - optional (for redundant network)
c. 12V DC AUX Power input - optional (required if you are not using PoE)
4. Carefully route the cables as shown.
NOTE: Some cables may have a protective boot over the RJ45 connector. The boots may not fi t into the TSC-7t cable cavity.
Refer to Figure 13
5. Carefully place the Base (1) onto the TSC-7t body (2). Make sure the cables are not pinched.
6. Secure the Base to the TSC-7t with the 4 screws (3) removed in "Prepare for Installation (both options)".
LAB A / PoE LAB B
— Figure 12 —
USB
Refer to Figure 14 (1)
USB 2.0 Micro-AB interface
TD-000508 -01 -A
12V DC
RESET
1
— Figure 14 —
8
— Figure 11 —
— Figure 13 —
1
2
3
1
2