General Requirements; Installation Confi Guration - QSC TSC-7t Installation Manual

Installation
The Q-Sys TSC-7t is designed to be mounted on a table, or desk.

General Requirements

The TSC-7t
• Must have access to the Q-LAN Ethernet.
• Must be mounted with suffi cient space for adequate ventilation.
• Mounting surface Thickness:
• Maximum – 4" (102 mm),
• Minimum – Not specifi ed
Installation Confi guration
Select one of the following:
1. Through the Table Mounting
a. TSC-7t
b. Mounting Surface (table, desk...)
c. Mounting Pipe - 31.6 mm (1.25 in), Nut and Washer
d. TSC-7t Cables - through the table
— Figure 3 —
Prepare for Installation (both options)
Refer to Figure 5
1. Remove the TSC-7t from the box.
2. Remove 4 screws (1) from the bottom of the assembly. Save for later use.
3. Remove the Base (2).
NOTE: If the Cable Cover (3) falls off during disassembly, be sure to replace it
before re-installing the Base (2).
TD-000508 -01 -A
(Figure 3)
a
b
c
d
Power Source
• PoE (Power over Ethernet – IEEE 802.3af class 3 device) LAN A only
• 12V DC AUX Power source (not supplied)
◦ 12V DC @ 1A (12W)
◦ Barrel connector:
» Negative contact – 5.5mm +/- 0.2mm
» Positive contact – 2.5mm +/- 0.2mm
» Length - 9.5mm +/- 0.3mm
2. Free Standing (Figure 4)
a. TSC-7t
b. Mounting Surface (table, desk...)
c. TSC-7t Cables - over the table
— Figure 4 —
1
6
a
b
c
2
3
— Figure 5 —