Miele Novotronic T 220 Operating Instructions Manual page 20

Problem solving guide
Problem
The drying process
goes on too long or
even switches off.
20
Possible cause
Important: Before attempting to remedy one of the fol-
lowing causes, switch the dryer off and switch on
again to start the programme again.
Ventilation to the dryer is
insufficient (e.g because it
is installed in a room
which is too small).
The laundry was not suffi-
ciently spun.
The tumble dryer has
been overloaded.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in
the laundry.
The fluff filter may be
blocked.
The vent ducting or the
ventilation outlet is
blocked.
Remedy
Open a door or window
while the machine is in op-
eration for increased air
flow.
Make sure that your laun-
dry is thoroughly spun be-
fore drying.
Do not exceed the maxi-
mum load for the
programme selected.
In future select a Timed
drying programme for
these garments.
Clean the fluff filter.
– Check all parts of the
extraction system on a
regular basis (e.g. wall
vent, external grille,
bends in the ducting
etc.) and make sure
they are all free of any
hindrance.
– Remove any fluff.