Table of Contents
Advertisement
◆ Connecting to a video player, etc.
Using the VIDEO terminal
COMPONENT
Y
PB/CB
PR/CR
S-VIDEO
VIDEO
Using the S-VIDEO terminal
COMPONENT
Y
PB/CB
PR/CR
S-VIDEO
VIDEO
When a TV tuner or VCR is connected:
When you use this projector with a TV tuner or VCR connected, no image may appear or a No Signal message may appear on the screen when
you change to a channel that is not being received. In this case, set the channels of the TV tuner or VCR again. To avoid this problem, use the
TV tuner or VCR with its channel skip function enabled. (Only channels that are being received will be displayed.)
◆ Connecting to a DVD player or HDTV decoder
This projector can be connected to a video equipment such as a DVD player or HDTV decoder. Be sure to connect component video output
terminals of the video equipment to the COMPONENT input terminals of this projector.
P
/C
P
/C
R
R
B
B
DVD player or HDTV decoder
12
Downloaded from
www.Manualslib.com
Video player, etc.
To VIDEO
output terminal
1
To VIDEO
input terminal
Video cable
(commercially available)
Video player, etc.
To S-VIDEO
output terminal
1
To S-VIDEO
input terminal
S-VIDEO cable
(commercially available)
Component cable
(commercially available)
Y
COMPONENT
Y
PB/CB
PR/CR
Y
S-VIDEO
VIDEO
manuals search engine
1. Connect one end (yellow) of a commercially available video
cable to the VIDEO input terminal of this projector.
2. Connect the other end (yellow) of the video cable to the
VIDEO output terminal of the video equipment.
2
1. Connect one end of the commercially available S-video
cable to the S-VIDEO input terminal of this projector.
2. Connect the other end of the S-video cable to the S-VIDEO
output terminal of the video equipment.
2
• Images may not be projected correctly depending on the type of
DVD player you use.
• It may take some time before an image is displayed on the screen
depending on the type of the input signal.
P
/C
B
B
P
/C
R
R
http://www.pureglare.com.au
Advertisement
Table of Contents
