Table of Contents
Advertisement
CAUTION! Computer components are extremely sensitive to electrostatic discharge
(ESD). Before handling any components, be sure to wear an anti-static wrist strap
(not included) and touch the computer case, to release any static electricity from
your body.
Preparation
Before you proceed, make sure that you have all the components that you plan to
install in the DiGiMatrix system.
Basic components to install
1. Hard disk drive (HDD)
2. Central processing unit (CPU)
3. DDR Dual Inline Memory Module (DIMM)
Removing the top cover
1.
On the rear panel, locate the two
screws that secure the top cover to the
chassis.
2.
Use a Phillips (cross) screw driver to
remove the top cover screws. Keep the
screws for later use.
3.
Pull the top cover slightly toward the
rear panel until the side tabs are
disengaged from the chassis.
4.
Hold the center edge of the top cover,
then lift it up from the chassis. Set the
top cover aside.
6
Hardware installation
1
2
4
ASUS DiGiMatrix (AB-V10)
3
Advertisement
Table of Contents
