Replacing Bulbs; Crash-Responsive Emergency Light Ing - Mercedes-Benz 2016 GLA Operator's Manual

adjusted using COMAND or Audio 20 (see the
separate Operator's Manual).
Manual interior lighting control
To switch the front interior lighting on:
X
set the switch to the c position.
To switch the front interior lighting off:
X
set the switch to the | position or (if the
door is closed) to the center position.
To switch the rear interior lighting on or
X
off: press the u button.
To switch the reading lamp on or off:
X
press the p button.
Crash-responsive emergency lighting
The interior lighting is activated automatically
if the vehicle is involved in an accident.
To switch off the crash-responsive
X
emergency lighting: press the hazard
warning lamp button.
or
Lock and then unlock the vehicle using the
X
SmartKey.

Replacing bulbs

Important safety notes
Xenon bulbs
DANGER
G
Xenon bulbs carry a high voltage. You can get
an electric shock if you remove the cover of
the Xenon bulb and touch the electrical con-
tacts. There is a risk of fatal injury.
Never touch the parts or the electrical con-
tacts of the Xenon bulb. Always have work on
the Xenon bulbs carried out at a qualified spe-
cialist workshop.
If your vehicle is equipped with Xenon bulbs,
you can recognize this by the following: the
cone of light from the Xenon bulbs moves
from the top to the bottom and back again
when you start the engine. For this to be
observed, the lights must be switched on
before starting the engine.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore make sure
that these function correctly at all times.
Have the headlamp setting checked regularly.
Other bulbs
G WARNING
Bulbs, lamps and connectors can get very hot
when operating. If you change a bulb, you
could burn yourself on these components.
There is a risk of injury.
Allow these components to cool down before
changing a bulb.
Do not use a bulb that has been dropped or if
its glass tube has been scratched.
The bulb may explode if:
you touch it
R
it is hot
R
you drop it
R
you scratch it
R
Only operate bulbs in enclosed lamps
designed for that purpose. Only install spare
bulbs of the same type and the specified volt-
age.
Marks on the glass tube reduce the service
life of the bulbs. Do not touch the glass tube
with your bare hands. If necessary, clean the
glass tube when cold with alcohol or spirit and
rub it off with a lint-free cloth.
Protect bulbs from moisture during opera-
tion. Do not allow bulbs to come into contact
with liquids.
There are bulbs other than the Xenon bulbs
that you cannot replace. Only replace the
bulbs listed ( page 122). Have the bulbs that
Y
you cannot replace yourself changed at a
qualified specialist workshop.
If you require assistance replacing bulbs, con-
sult a qualified specialist workshop.
If the new bulb still does not light up, consult
a qualified specialist workshop.
Replacing bulbs
Z
121