Batch Mode; Track Extraction - MicroBoards Technology Orbit II Reference Manual

6.7 Batch Mode

Batch mode allows you to load masters and blanks into the input hopper to duplicate from multiple masters
while leaving the Orbit II unattended. Masters are automatically detected and stored temporarily on the
internal hard drive, then copied to each blank that follows until the next master is detected.
When using Batch mode, the first disc inserted must be a master. Also, masters must be separated by at
least one blank disc.
To enter Batch Mode:
•
Press Yes when the display reads
•
Load the first master, then the number of blanks required, then the next master and blanks.
Repeat as necessary, with a limit of 50 discs in the input hopper.
•
Press Yes at
to choose the other batch copy option,
•
When the duplication is complete and the input hopper is empty, you will be given the option of
adding discs to the input hopper and continuing, or ending the batch copy. Press Yes after adding
media to continue the batch copy, or press No to halt the batch copy and return to the batch mode
option selected in the step above.
NOTE: Exiting batch mode will set the master source as Disc to Disc for non-batch Copy or non-batch
Copy and Compare. If you had selected a hard drive source prior to the batch copy and want to
use that hard drive source again, you will need to reset the System Setup to that hard drive source
(see section 6.3).
Batch Mode will not duplicate CD+G or allow duplication by Track Extraction.
6.8 Track Extraction (Audio CD Only)
NOTE: TRACKS CAN ONLY BE EXTRACTED FROM AUDIO CD MASTERS
To select Track Extraction:
•
Press Yes when the display reads
•
Insert a master audio disc in the reader at the
display prompt. The Orbit II will retract the reader tray and analyze the master disc after the Yes
button is pressed.
•
Press Yes at
track. In this example, the master has a total of 12 tracks.
•
After selecting or skipping the last track, press Yes to finish extraction or No to reselect tracks from
this master.
END EXTRACTION?
Batch Mode?
B_Copy?
Trk Extraction?
Extract? 01/12
Since this master has a total of 12 tracks, you are asked if you would
like to end the extraction after the 12
Orbit II Disc Copier Reference Manual – Revision K
to begin the batch mode copy. Pressing No will allow you
B_Copy & Compare?
. The reader drive will open.
Load Master Disc / press YES key..
to select the track for extraction or No to skip this
30
th
track.