Desa NY100 Safety Information And Installation Manual page 9

Unvented (vent-free) blue flame remote control gas heater
Table of Contents

Advertisement

INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Re-
move mounting bracket from heater carton.
Figure 5 - Mounting Bracket
Removing Front Panel Of Heater
1. Remove the four painted screws, two on
each side of front panel.
2. Pull bottom of front panel forward, then
out.
3. Remove any remaining packaging ma-
terials.
Front Panel
12"
(30.4
Figure 6 - Removing Front Panel Of
cm)
Min.
Methods For Attaching Mounting Bracket
Only Insert Mounting
To Wall
Screws Through Last
Only use last hole on each end of mounting
Hole On Each End
bracket to attach bracket to wall. These two
holes are 14" apart from their centers. Attach
mounting bracket to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud:
strongest hold. Insert mounting screws through
mounting bracket and into wall studs.
Attaching to Wall Anchor:
you to attach mounting bracket to hollow walls
(wall areas between studs) or to solid walls
(concrete or masonry).
118620-01E
Screw
14" (35.6 cm)
Heater
(47.6 cm)
Floor
This method provides the
This method allows
www.desatech.com
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall where
heater will be located. Make sure mount-
ing bracket is level.
WARNING: Maintain mini-
mum clearances shown in
Figure 7. If you can, provide
greater clearances from floor
and joining wall.
2. Mark screw locations on wall (see Figure 7).
Note: Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from
wall.
12"
(30.4
cm)
Min.
(20.3
cm)
Min.
18
/
"
3
4
Min.
Figure 7 - Mounting Bracket Clearances
14" (35.6 cm)
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
30,000 Btu/Hr Models
8"
14" (35.6 cm)
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
20,000 Btu/Hr Models
(2
18
/
"
3
4
(47.6 cm)
Min.
18
/
"
3
4
(47.6 cm)
Min.

8
c
M

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents