Table of Contents
Advertisement
OpERATING HEATER
Continued
3. MODE - Indicates operation MODE of
system. ON indicates system is on either
manually or thermostatically. OFF indi-
cates entire system is turned off. THER-
MO indicates system will automatically
cycle on and off depending on program.
4. SET - Indicates desire set room tempera-
ture for THERMO operation.
5. FLAME - Indicates burner and valve in
operation.
6. CLOCK - Indicates current time in AM or PM.
7. ROOM - Indicates CURRENT room tem-
perature.
8. °F indicates degrees Fahrenheit (°C indi-
cates degrees Celsius).
P1
P
1
7
1
ROOM
6
Figure 25 - LCD Display
Buttons
MODE - Changes modes from ON, THERMO
and OFF.
DOWN - Lowers set temperature in THERMO
mode.
UP - Increases set temperature in THERMO
mode
TIME/PROGRAM - Activates time setting and
ROOM
activates PROGRAM mode.
SET - Used to set clock and timer.
DOWN
TIME/PROGRAM
Figure 26 - Mode Buttons
Setting the Clock
Slide open plastic cover on front of remote
control to expose setting buttons.
118620-01E
2
P2
ON
AM
OFF
P
2
PM
THERMO
SET
PM
FLAME
OFF
SET
PM
Mode
Button
UP
SET
www.desatech.com
The cover protects buttons from being changed
accidentally. Close cover after completing the
following settings and programming.
1. Press and hold TIME/PROGRAM button
on remote control for more than 2 sec-
onds. Hour digit(s) will begin flashing.
2. Press UP or DOWN button until desired
hour is displayed in AM or PM.
3. Press and release TIME/PROGRAM
button again and minute digits will begin
flashing.
4. Press UP or DOWN button until desired
minutes are displayed.
5. Press and release SET button on remote
control to stop time digits from flashing
and set the time.
Note: Flashing numbers on display indicate
system is awaiting user input, such as using
UP and DOWN buttons to program a new
setting. If no change is made to flashing dig-
3
its within 15 seconds, system will complete
8
procedure last programmed and reset the
display to its normal state.
4
Setting Fahrenheit and Celsius Scale
Factory setting for temperature is 0° F. To
5
change this setting to 0° C, press UP but-
ton and DOWN button on remote control at
the same time to change from 0° F to 0° C.
Follow this same procedure to change from
0° C back to 0° F.
Manual Function
To operate system in ON manual mode, press
MODE button. The flame icon will come on.
The word ON and the flame icon will appear
on LCD screen in ON mode.
To operate system in OFF manual mode,
press MODE button again. The FLAME icon
will shut off. The word OFF will appear on
LCD screen. The flame icon will not appear
on LCD screen in OFF mode.
Thermostat Function
This remote control system can be thermo-
statically controlled when remote control is
in THERMO mode (THERMO must be dis-
played on the screen). To set desired room
temperature, press MODE button to place re-
mote control into THERMO mode, then press
UP or DOWN button to select desired room
temperature. Within 5 seconds appliance will
turn on or off. The highest SET temperature
is 99° F (37° C). The lowest SET temperature
is 45° F (8° C). The factory set number will
be 45° F (8° C).
17
Hide quick links:
Advertisement
Table of Contents
