Display Explanation; Features; Operating Instruction - GRAUPNER Polaron Operating Manual

Overload(Current)
Guage
2.5A/ Section
ex) 5 sections = 2.5AX5
• The stable DC 12V output by switching power supply system.
• The rated 25A (Max 30A) is able to c over all of Graupner/SJ charger.
• AC100-240V/50~60Hz Input.
• 0~40°C Category temperature range.
• Short circuit / Over voltage / Over current / Over power protection function.
• 100% full load burn-in test.
• Built in ON/ OFF switch.
• Heat suppression design by built in cooling fan and compact circuit.
• Several devices can get the power from multi-output at a time.
• 5.0V, 1.0A output throughout USB terminal.
• Short sensing circuit design.
• Easy to carry by small size and light weight.
• Docking system with POLARON EX/PRO Charger.
• Easy to check the actual voltage and current on LCD.
• Enable to check the external temperature on LCD.
1. Read thoroughly the following instruction before using.
2. Disconnect the power supply from AC main power before connecting the device to the power supply.
3. Connect the device to the power supply ensuring the correct polarity. Red is positive, Black is negative.
4. Connect to the charger (POLARON EX/PRO) that can be used in Docking system with the double gold connector.
5. Switch " OFF " with the switch on the rear of this unit and connect AC power cable.
6. Switch " ON " with the switch on the rear of this unit then this unit initiates to supply the power.
NOTICE: The actual voltage and current should be in the specification of this unit.
14
7.

DISPLAY EXPLANATION

8.

FEATURES

9.

OPERATING INSTRUCTION

The actual output
voltage from SMPS
The actual output
current from SMPS
The external
temperature