Cargo Management System - GMC Yukon 2007 Owner's Manual

4. Press the end caps in, this will allow the cover
to fit into the trim slot.
5. Lightly pull on the cover holder to make sure
it is secure.
On the extended wheelbase models there are
two cover positions. The slots furthest
forward allow the cover to be used if the third
seat is removed or folded down. The cover
can be installed and removed from either side.
Cargo Tie Downs
Your vehicle may have cargo tie downs in the rear
cargo area that allow you to strap cargo in and
keep it from moving inside the vehicle.

Cargo Management System

Your vehicle may be equipped with a cargo
management system. It can be used for storing
and separating cargo and as a table. The
maximum load is 200 lbs. (91 kg) distributed. It is
located in the rear of the vehicle on upper or
lower horizontal guides. There are two vertical
curved guides that connect the upper and
lower horizontal guides together. The system has
three rollers on each side. The system has a
194
release lever located in the center of the grab
handle. This will engage and disengage a locator
pin. This is used in adjusting and positioning
the system.
The cargo management system can be positioned
on the upper or lower horizontal guides.
To adjust the system from the upper position to
the lower position, do the following:
1. Squeeze and hold the release lever to retract
the locator pin.
2. Pull the system back until the front rollers
reach the vertical curved guides.