Part 4 - Piping - Westinghouse WGR-076 Series Installation, Start-Up, Maintenance, Parts, Warranty

Figure 3 - Water Heater Dimensions - NOTE: All Dimensions Are Approximate
BTU/Hr Efficiency (°F)
(°C)
GPH
76,000 97%
LPH
Table 3 - Recovery on Rating Plate is based at 97% Thermal Efficiency at 70

Part 4 - Piping

Failure to follow the instructions in this section WILL VOID the
warranty and may result in property damage, severe personal
injury, or death.
Performance Specifications for High Efficiency Water Heater Models
Temperature Rise in Degrees Fahrenheit (F) and Celsius (C)
40 50 60
22 28 33
231 187 158
874 708 598
70 80 90
39 44 50
135 119 107
511 450 405
o
Fahrenheit rise, as required by ANSI
Dielectric unions or galvanized steel fittings must not be used
in a system with this water heater. Doing so WILL VOID the
warranty. Use only copper, brass, or stainless steel fittings.
Teflon thread sealant must be used on all connections.
DO NOT pipe this water heater with black iron, galvanized steel,
steel, or lead pipe. Doing so will result in premature product
failure and property damage, and WILL VOID the warranty.
100 110 120 130
56 61 67 72
97 86 79 73
367 326 299 276
WHL-001 Rev. 3.16.15
11
140
78
69
261