Akai MPC5000 Reference Manual page 168

154 Effects
HP / LP Shelving Filter
This filter differs from the standard filter type in that all frequencies affected by the cutoff point are attenuated equally.
Freq
Res
Gain
2-Band, 2-shelf PEQ
This effect is a combination of a two-band parametric equalizer and two shelving filters.
This effect is best used as an insert by turning 'DIRECT' off. See page 150 for more on this.
LowFreq
LowGain
HiFreq
HiGain
Freq1
Gain1
Q1
Freq2
Gain2
Q2
4-Band PEQ
This effect is a powerful four band parametric equalizer, with four independent EQ points.
This effect is best used as an insert by turning 'DIRECT' off. See page 150 for more on this.
Freq1
Freq2
Freq3
Freq4
Q1
Q2
Q3
Q4
Gain1
Gain2
Gain3
Gain4
Controls the frequency at which the filter will affect the incoming signal.
Controls the emphasis of the frequency at the cutoff point.
Adjusts the level of the output signal.
Sets the frequency at which the low shelf will start to affect the incoming signal.
Sets the volume amount that the low shelf will attenuate or boost the incoming signal.
Sets the frequency at which the high shelf will start to affect the incoming signal.
Sets the volume amount that the high shelf will attenuate or boost the incoming signal.
Sets the frequency of the first band of the parametric EQ.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq1.
This parameter sets the width of the band that is being affected by Freq1.
Sets the frequency of the second band of the parametric EQ.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq2.
This parameter sets the width of the band that is being affected by Freq2.
Sets the frequency of the first band of the parametric EQ.
Sets the frequency of the second band of the parametric EQ.
Sets the frequency of the third band of the parametric EQ.
Sets the frequency of the fourth band of the parametric EQ.
This parameter sets the width of the band that is being affected by Freq1.
This parameter sets the width of the band that is being affected by Freq2.
This parameter sets the width of the band that is being affected by Freq3.
This parameter sets the width of the band that is being affected by Freq4.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq1.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq2.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq3.
Sets the amount of attenuation or boost that will be applied around the frequency selected
with Freq4.