Meyer Sound M SERIES Operating Instructions Manual page 38

APPENDIX B
Input level
AMPLIFIERS
Amplifier type
Output power
THD, IM TIM
Load capacity
Cooling
AC POWER
AC power connector
Voltage selection
Safety agency rated
operating voltage
Turn on/turn off points
Current Draw
Idle current
Max. long-term continuous
current (>10 sec)
Burst Current (<1 sec)
Ultimate short-term peak
current draw
Inrush current
RMS NETWORK
PHYSICAL
Enclosure
Finish
Protective grille
Rigging
Dimensions
Weight
32
Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk)
into 600 ohms in order to produce maximum peak SPL over the operating bandwidth of the
loudspeaker.
Two-channel complementary MOSFET output stages (class AB/H)
2250 W total
Note: Wattage rating is based on the maximum unclipped burst sine-wave rms voltage the
amplifier will produce into the nominal load impedance — both channels 67 V rms (95 V pk).
< .02%
4 Ω each channel
Forced air cooling, 2 fans total (1 ultrahigh-speed reserve fan)
PowerCon or VEAM
Automatic, two ranges, each with high-low voltage tap (uninterrupted)
95 V AC - 125 V AC; 208 V AC - 235 V AC; 50/60 Hz
85 V AC - 134 V AC; 165 V AC - 264 V AC; 50/60 Hz
0.640 A rms (115 V AC); 0.320 A rms (230 V AC); 0.850 A rms (100 V AC)
8.8 A rms (115 V AC); 4.4 A rms (230 V AC); 10 A rms (100 V AC)
19 A rms (115 V AC); 9.5 A rms (230 V AC); 22 A rms (100 V AC)
39 A pk (115 V AC); 20 A pk (230 V AC); 45 A pk (100 V AC)
7 A pk (115 V AC); 7 A pk (230 V AC); 10 A pk (100 V AC)
Equipped for two conductor twisted-pair network, reporting all operating parameters of
amplifiers to system operator's host computer.
Multi-ply hardwood
Black textured
Powder-coated hex stamped steel
Patented QuickFly MRF-2D-Sub rigging frame with CamLinks and quick release pins
39.00" w x 24.00" h x 17.50" d (991 mm x 610 mm x 445 mm)
24.00
[610 mm]
37.00
[940 mm]
39.00
[991 mm]
17.50
[445 mm]
19.50
[495 mm]
173 lbs (78.47 kg); Shipping: 197 lbs (89.35 kg)
21.86
[555 mm]
11.25
[286 mm]
8.50
[216 mm]