Meyer Sound M SERIES Operating Instructions Manual page 36

M series compact curvilinear array loudspeaker and compact subwoofer
Hide thumbs Also See for M SERIES:
Table of Contents

Advertisement

APPENDIX B
RF filter
TIM filter
Nominal input sensitivity
Input level
AMPLIFIER
Amplifier type
Output power
THD, IM TIM
Load capacity
Cooling
AC POWER
AC power connector
Voltage selection
Safety agency rated
operating voltage
Turn on/turn off points
Current Draw
Idle current
Max. long-term continuous
current (>10 sec)
Burst Current (<1 sec)
Ultimate short-term peak
current draw
Inrush current
RMS NETWORK
PHYSICAL
Enclosure
Finish
Protective grille
Rigging
Dimensions
17.47
[444 mm]
Weight
30
12.12
[308 mm]
37.00
Common mode: 425 kHz; Differential mode: 142 kHz
<80 kHz, integral to signal processing
0 dBV (1 V rms, 1.4 V pk) continuous is typically the onset of limiting for pink noise and music.
Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk)
into 600 ohms in order to produce maximum peak SPL over the operating bandwidth of the
loudspeaker.
Two-channel complementary MOSFET output stages (class AB/bridged)
700 W total
Note: Wattage rating is based on the maximum unclipped burst sine-wave rms voltage the
amplifier will produce into the nominal load impedance — low channel 30 V rms (42 V pk);
high channel 32 V rms (45 V pk)
< .02%
2 Ω low channel, 8 Ω high channel
Convection cooling. 24 V DC output for optional external fan.
PowerCon or VEAM
Automatic
100 V AC - 240 V AC; 50/60 Hz
Continuous 90 V AC - 265 V AC; 50/60 Hz
Note: No automatic turn-off voltages. Voltages above 265 V AC are fuse protected but
may cause permanent damage to the power supply. Voltages below 90 V AC may result in
intermittent operation.
0.35 A rms (115 V AC); 0.35 A rms (230 V AC); 0.35 A rms (100 V AC)
3.1 A rms (115 V AC); 1.6 A rms (230 V AC); 3.6 A rms (100 V AC)
3.2 A rms (115 V AC); 1.6 A rms (230 V AC); 3.7 A rms (100 V AC)
5.8 A pk (115 V AC); 2.9 A pk (230 V AC); 6.7 A pk (100 V AC)
9 A pk (115 V AC); 9 A pk (230 V AC); 8 A pk (100 V AC)
Equipped for two conductor twisted-pair network, reporting all operating parameters of
amplifiers to system operator's host computer.
Multi-ply hardwood
Black textured
17.47
Powder-coated hex stamped steel
[444 mm]
Patented QuickFly MRF-2D rigging frame with CamLinks and quick release pins
39.00" w x 12.12" h x 17.47" d (991 mm x 308 mm x 444 mm)
12.12
[308 mm]
8.74
[222 mm]
19.56
[497 mm]
116 lbs (52.62 kg); Shipping 130 lbs (58.97 kg)
6.06
[154 mm]
8.74
[222 mm]
19.56
[497 mm]
6.06
[154 mm]
37.00
[940 mm]
39.00
[991 mm]
9.99
[254 mm]
9.99
[254 mm]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M2dM2d-sub

Table of Contents