JVC GR-DVP7 Instructions Manual page 76

76
EN
Automatic Editing To VCR
Remote sensor
Downloaded From VideoCamera-Manual.com Manuals
USING THE REMOTE CONTROL UNIT (cont.)
Recording Start/
Stop Button
START/STOP
PAUSE
R.A.EDIT
ON/OFF
VCR REC
STBY
13
Rewind the tape in the camcorder to the
beginning of the scene you want to edit and press
PAUSE (9).
14
Point the remote control towards the VCR's
remote sensor and press VCR REC STBY (79), or
manually engage the VCR's Record-Pause mode.
15
Press START/STOP
on the remote control.
Editing proceeds as
programmed, right
through to the end of
the last registered
scene.
● When dubbing is
complete, the camcorder enters the Pause
mode, and the VCR enters its Record-Pause
mode.
● If you do not register an Edit-Out point, the
tape will be dubbed all the way to the end
automatically.
● If you operate the camcorder during automatic
editing, the VCR will enter its Record-Pause
mode and automatic editing will stop.
16
Engage the Stop modes for the camcorder and
the VCR.
To make the R.A.Edit counter display disappear,
press R.A.EDIT ON/OFF on the remote control.
NOTES:
● Pressing R.A.EDIT ON/OFF on the remote control
clears all settings registered during Random
Assemble Editing.
● When the editing cable is connected to the remote
control's PAUSE IN connector during dubbing,
make sure the remote control is pointed at the
VCR's sensor, and the path between the two is
unobstructed.
● Random Assemble Editing may not function
properly when using a tape including several
duplicated time codes. (
N I OUT MODE
00 : 2 5 ~ 02 : 05
1 – –
2 07 : 18 ~ 08 : 31 – – – –
3 – – 0 3 : 33 ~ 05 : 53
4 09 : 30 ~ 13 : 15
5 15 : 55 ~ 16 : 29 – – – –
6 – – – – – – : ~
7 ~
8 ~
T I ME CODE 1 6 : 3 0
TOTAL 9 : 39
pg. 21)