Panasonic DBS 824 Manual page 154

Hide thumbs Also See for DBS 824:

Table of Contents

SMDR Start Timer for CO Calls

Software Version CPC-S and CPC-M, Version 1 0 and higher

This timer determines how long the system waits before starting an SMDR

record for the call (both outgoing and incoming) For example, if the timer is

set to 5 seconds, SMDR recording of call data will begin 5 seconds after an

outgoing number is dialed or 5 seconds after an incoming call is answered

For outgoing calls, the purpose of this timer is to allow the CO to connect the

call, or the called party to answer, before beginning SMDR timing For

incoming calls, the purpose of this timer is to limit the nurnber of SMDR

records for incoming calls (e g , if an incoming call lasts for less than 30

seconds, and this SMDR Start Timer is set for 30 seconds, an SMDR record

will not be generated for that call)

Related Programming

SMDR Printing Mode 1 -- Outbound and Inbound FFl 2# 2# 6#

SMDR Printing Mode 2 -- Long-Distance and Local Calls

SMDR Report FF3 (ExtPort)# 14#

0= 5 seconds

DBS 824-l O-400

issued 3/l @5

Chapters

Table of Contents