Voyager Rf Scanner - Overview - Metrologic MS9530 Series Installation And User Manual

Product Overview
The MS9530 Series Voyager RF is a wireless single line hand-held scanner
with one bi-directional RF channel radio which provides about 20-30 meters
portability.
It has got a battery pack which can be removed from the unit to be charged
through a Wall-Power supply in about 110 min. No charging stand is required.
Once charged the unit can read and transmit more than 30,000 readings. In
order to save the battery charge, the unit will enter into standby mode, when left
idle. To "wake" the unit, and begin scanning, simply press the CodeGate button
located on the head of the scanner. When idle mode, the battery is still
supplying the unit and its charge will last for approximately 5 days.
To interface with the host, a Base Station is provided which allows the scanner
to transfer data to Host via various interfaces, including: Wedge, RS232, Light
Pen and OCIA emulation.
Every time the unit is activated, it will try to link with the Base Station for a few
seconds. In the event that there is no response, for example, the Base Station
is turned off or the unit is out of range etc, the scanner will give an error beep
and will keep the unit locked with the Green and Red LEDs "on" until the user
presses the CodeGate button. Once pressed, the unit will work normally once
the problem is solved.
The unit has Green and Red LED indicators to inform the user of the scanner's
status. Basically, the Green LED is used for scanning issues and the Red LED
is used for radio transmissions.
There is also a beeper which provides an audible indicator for low battery,
errors, successful operations, programming mode and start up diagnostics.
As long as the Voyager RF has got a decoder built-in, it has got its own
programming manual which can be used to program decoding issues as well as
the RF interface (Base Station serial number, Mobil ID, and so on....)
3
MS9530 Voyager RF Printed: September 2002
Version: 1.1 Status: Approved