Connecting The Base Station To The Host - Metrologic MS9530 Series Installation And User Manual

CONNECTING THE BASE STATION TO THE HOST

WEDGE INTERFACE
1. Turn off the Host system
2. Connect the cable Y-XX between the keyboard and Host
When Power supply required (it is recommended all the times
3.
for better RF transmissions), check that the voltage matches
the AC outlet and then connect
Power up the Host system
4.
RS232 INTERFACE
1. Turn off the Host system
2. Connect the cable RS232(DB25/DB9) to the desired RS232
input port of the Host
When Host can't provide power supply, check that the voltage
3.
matches the AC outlet and then connect
Power up the Host system
4.
LIGHT PEN AND OCIA INTERFACES
Technical assistance will be required depending on the HOST interface.
Now follow the matching procedures to link the Voyager RF to the Base Station
MS9530 Voyager RF
Version: 1.1
6
Printed: September 2002
Status: Approved