Kenwood KMM-BT515HD Instruction Manual page 36

Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
(For
(For
)
(F) Screws (supplied for
32
Installing the unit (in-dash mounting)
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied/
commercially available).
Use only the specified screws. Using wrong screws might damage the unit.
/
How to remove the unit
/
1
Detach the faceplate.
)
2
Fit the catch pin on the
extraction keys into the holes
on both sides of the trim plate,
then pull it out.
)
3
Insert the extraction keys
deeply into the slots on each
side, then follow the arrows as
shown on the right.
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
(For )
Do the required wiring.
( 33, 34)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
(For /
/ )