Kenwood KMM-BT515HD Instruction Manual page 22

BLUETOOTH®
To
While talking on the first incoming call...
Answer another incoming
call and hold the current
call
Reject another incoming
call
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then press the
knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
18
On the faceplate
Press .
Press .
Press .
Press .
Turn the volume knob during
a call.
• This adjustment will not
affect the volume of the other
sources.
Press during a call.
• Operations may vary
according to the connected
Bluetooth device.
.
On the remote control
MIC GAIN
Press .
NR LEVEL
Press .
ECHO CANCEL
Press .
Make the settings for receiving a call
1
Press
Press .
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3
Repeat step
activated.
4
( Not available )
Press and hold
To return to the previous setting item, press
( Not available )
SETTINGS
AUTO ANSWER
BATT/SIGNAL*
* Functionality depends on the type of the phone used.
–10 — +10 (–4): The sensitivity of the microphone
increases as the number increased.
–5 — +5 (0): Adjust the noise reduction level
until the least noise is being heard during a phone
conversation.
–5 — +5 (0): Adjust the echo cancellation delay
time until the least echo is being heard during a
phone conversation.
to enter Bluetooth mode.
2
until the desired item is selected or
to exit.
1 — 30: The unit answers incoming call
automatically in the selected time (in seconds). ;
OFF: Cancels.
AUTO: Shows the strength of the battery and signal
when the unit detects a Bluetooth device and the
Bluetooth device is connected. ; OFF: Cancels. Clock
time is shown.
Default: XX
.
Default: XX