Troubleshooting - Kenwood KMM-BT515HD Instruction Manual

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
(For )
"SET ERROR" / "DEL ERROR"
• Radio reception is poor.
• Static noise while listening
to the radio.
"READING" keeps flashing.
Elapsed playing time is not
correct.
"LOADING" appears when you
enter search mode by pressing
.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated
properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 28)
Reset the unit. ( 3)
Setting/deleting the remote control ID is
unsuccessful. Turn the power off, then turn on
the power and perform the operation again.
( 5)
Connect the antenna firmly.
Do not use too many hierarchical levels or folders.
This is caused by how the files are recorded.
This unit is still preparing the iPod/iPhone music
list. It may take some time to load, try again later.
Symptom Remedy
• This unit can only display uppercase letters, numbers,
Correct characters are not
displayed (e.g. album
• Depending on the display language you have selected
name).
"NA FILE" Make sure the media contains supported audio files.
( 28)
"READ ERROR" Copy the files and folders onto the USB device again. If
this does not solve the problem, reset the USB device or
use another USB device.
"NO DEVICE" Connect a USB device, and change the source to USB
again.
"COPY PRO" A copy-protected file is played.
"NA DEVICE" Connect a supported USB device, and check the
connections.
"NO MUSIC" Connect a USB device that contains playable audio files.
• Reconnect the iPod.
"iPod ERROR"
• Reset the iPod.
• Sound cannot be heard • Reconnect the Android device.
• If in [HAND MODE], launch any media player
during playback.
• Sound output only from
• If in [HAND MODE], relaunch the current media
the Android device.
• Restart the Android device.
• If this does not solve the problem, the connected
and a limited number of symbols.
( 5), some characters may not be displayed
correctly.
application on the Android device and start playback.
player application or use another media player
application.
Android device is unable to route the audio signal to
unit. ( 28)
ENGLISH
25