Table of Contents
Advertisement
Command Line Interface (CLI)
–
DHCP Server Parameters
–
Link Integrity Parameters
•
Interface Parameters
–
Wireless Interface Parameters
—
Wireless Distribution System (WDS) Parameters
–
Ethernet Interface Parameters
•
Management Parameters
–
SNMP Parameters
–
HTTP (web browser) Parameters
configure the SSL certificate passphrase.
–
Telnet Parameters
–
Serial Port Parameters
–
TFTP Server Parameters
–
IP Access Table Parameters
–
Auto Configuration Parameters
automatically configured by downloading a configuration file from a TFTP server during boot up.
•
Filtering Parameters
–
Ethernet Protocol Filtering Parameters
–
Static MAC Address Filter Table
–
Proxy ARP Parameters
–
IP ARP Filtering Parameters
–
Broadcast Filtering Table
–
TCP/UDP Port Filtering
•
Alarms Parameters
–
SNMP Table Host Table Parameters
–
Syslog Parameters
•
Bridge Parameters
–
Spanning Tree Parameters
–
Storm Threshold Parameters
–
Intra BSS Subscriber Blocking
–
Packet Forwarding Parameters
•
Security Parameters
–
Wireless Interface Security Parameters
–
MAC Access Control Parameter
•
RADIUS Parameters
–
Primary and Backup RADIUS Server Table Parameters
•
Rogue Access Point Detection (RAD) Parameters
•
VLAN/SSID Parameters
•
Other Parameters
–
IAPP Parameters
–
SpectraLink VoIP Parameters (802.11b Only)
- Enable or disable dynamic host configuration
- Monitor link status
- Configure Wireless and Ethernet settings
- Set the speed and duplex of the Ethernet port
- Control access to the AP's management interfaces
- Set read and read/write passwords
- Set up the graphical web browser interface. If required, enable SSL and
- Telnet Port setup
- Serial Port setup
- Set up for file transfers; specify IP Address, file name, and file type
- Configure range of IP addresses that can access the AP
- Configure the Auto Configuration feature which allows an AP to be
- Control network traffic based on protocol type
- Enable and disable specific addresses
- Enable or disable proxy ARP for wireless clients
- Control which ARP messages are sent to wireless clients based on IP settings
- Control the type of broadcast packets forwarded to the wireless network
- Filter IP packets based on TCP/UDP port
- Enter the list of IP addresses that will receive alarms from the AP
- Configure the AP to send Syslog information to network servers
- Used to help prevent network loops
- Set threshold for number of broadcast packets
- Enable or disable peer to peer traffic on the same AP
- Redirect traffic from wireless clients to a specified MAC address
- Access Point security settings
- Configure WEP encryption settings
- Control wireless access based on MAC address
- Configure mutiple subnetworks based on VLAN ID and SSID pairs.
- Enable or disable the Inter-Access Point Protocol
- Configure the WDS partnerships
- RADIUS Authentication and Accounting information
- Enable and configure Rogue Access Point Detection.
- Enable or disable SpectraLink Voice over IP feature
C-25
Advertisement
Table of Contents
