Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR PART OESWC-1761-RF
The OESWC-1761-RF is designed to allow you to add steering wheel
control options to 2003 and up Toyota vehicles without an amplifi ed
system. With a factory radio that has the 20 pin connector, the RF
controlled OESWC-1761-RF will allow the customer to adjust their
radio without taking their eyes off the road. The OESWC-1761-RF will
come preprogrammed with your most popular features, volume up,
volume down, seek up, seek down, and source. But with the option of
remapping the buttons to fi t every customer needs, this makes this a
INTERFACE COMPONENTS
• A) OESWC Transmitter • B) OESWC Interface • C) Center Keypad
• D) Trim Ring • E) Strap Cover • F) Vehicle T-Harness
A
TOOLS REQUIRED FOR INSTALLATION
•Connectors (I.E. butt-connectors, bell caps, ECT...)
1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
OESWC-1761-RF
must have interfaces that the Axxess line offers.
B
E
•Cutting Tool •Tape •Crimping Tool
C
D
F
axxessinterface.com
Advertisement
Related Manuals for Metra Electronics OESWC-1761-RF
Summary of Contents for Metra Electronics OESWC-1761-RF
- Page 1 INSTALLATION INSTRUCTIONS FOR PART OESWC-1761-RF OESWC-1761-RF The OESWC-1761-RF is designed to allow you to add steering wheel control options to 2003 and up Toyota vehicles without an amplifi ed system. With a factory radio that has the 20 pin connector, the RF controlled OESWC-1761-RF will allow the customer to adjust their radio without taking their eyes off the road.
- Page 2 Mounting The RFASWC Transmitter 1. Place button pad in the OESWC transmitter with the volume up arrow (^) in the spot where you want volume up to be.(fig. 1) 2. Snap in trim ring to secure keypad in place. (fig. 2) 3.
- Page 3 Wiring The OESWC Interface 1. Connect the red wire to 12 volt accessory 2. Connect the Black wire to ground (you may use the same ground that you use for the aftermarket radio) Setting Up The OESWC Transmitter 1. Press the Red and Green buttons simultaneously for 5 seconds, and then press volume up for two seconds.
- Page 4 for 2 seconds. 5. This is the end of the auto detection stage. If the OESWC TRANSMITTER detected the vehicles radio successfully the led will light up solid red. 6. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.
-
Page 5: Replacing The Battery
Replacing the battery The battery that is used in the OESWC-RF is a CR2032. To replace it please follow the instructions below. 1. Remove the OESWC-RF from the steering wheel by removing the Phillips screw from the back of the OESWC-RF and undoing the strap. - Page 6 NOTES...
- Page 7 NOTES...
- Page 8 INSTALLATION INSTRUCTIONS FOR PART OESWC-1761-RF 1-800-221-0932 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION NOWLEDGE IS Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.