Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-7606 (With Dual Zone Climate Controls) 2006-07 Nissan Pathfinder Armada 2006-07 99-7606 KIT FEATURES • DIN Radio Provision with pocket • ISO Radio Unit Provision with pocket • Double DIN Radio Provision • Stacked ISO Head Units Provision KIT COMPONENTS A) Radio Housing •...
- Nissan Pathfinder Armada 2006-07...1, 2 Kit Assembly: • Pre-Kit Assembly...3 - DIN Radio Provision with Pocket ...4 - ISO Radio Provision with Pocket ...5 - Double DIN Radio Provision ..6 - Stacked ISO Head Units Provision ...7 Final Assembly ...8 • 99-7606...
NOTE: The small round Airbag stick- er also needs to be removed from the factory panel and placed onto the 99-7606 radio housing panel. (A round piece of double-sided tape is provided in case the factory stick- er is not strong enough.) (Figure C)
Page 4
(Figure D) Note: The small round sticker also needs to be removed from the factory panel and placed onto the 99-7606 radio housing. Continue to kit assembly. DASH DISASSEMBL Y INSIDE VIEW - RADIO TRIM PANEL BACK...
99-7606 NISSAN TITAN 2006-07 NISSAN PATHFINDER ARMADA 2006-07 Attach the a/c control to the 99-7606 Radio Housing using the factory hardware removed in the dash dis- assembly. (Figure A) Snap the outer trim rings onto the a/c control knobs. (Figure B)
99-7606 DIN RADIO PROVISION WITH POCKET Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) Slide the aftermarket radio unit into the cage and secure. (Figure B) Snap the pocket into the radio housing.
99-7606 ISO RADIO PROVISION WITH POCKET Mount the ISO Brackets to the radio with the screws supplied with the radio. (Figure A) Slide the radio into the radio opening until the side clips engage. (Figure B) Snap the Trim plate into the Radio Housing.
99-7606 DOUBLE DIN RADIO UNIT PROVISION Cut and remove center divider from radio housing. (Figure A) Snap the Double DIN brackets to the inside edge of the radio hous- ing. (Figure B) Slide the Double DIN radio into the Double DIN bracket/radio housing...
99-7606 STACKED ISO HEAD UNITS PROVISION Cut and remove center divider from radio housing. (Figure A) Snap the Double DIN brackets to the inside edge of the radio hous- ing. (Figure B) Slide the stacked ISO units into the Double DIN bracket/radio housing...
Dimmer ..Orange / White *NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer’s specifications. 99-7606 FINAL ASSEMBL Y Strip wire ends back 1/2"...