Resetting Data; Scanning Service Messages - Viessmann vitotronic 300-k Operating Instructions Manual

Vitotronic 300-K Operating
Scanning Information

Resetting Data

Scanning Service Messages

(continued)
Service address
If your heating contractor has entered their details, you
can scan these.
From the home screen tap the following buttons:
1. "Menu"
2. "Information"
3. "Service contact details" Each text box is limited to
45 characters.
Note: If there are no details, tap the white field.
The keyboard appears (see page 22).
You can reset the following data:
H In conjunction with a solar thermal system:
Solar energy yield, solar circuit pump
hours run and hours run output 22.
H All the above data simultaneously.
From the home screen tap the following buttons:
1. "Menu"
2. "Information"
3. "Reset data"
4. Select required data point or "All details".
5. Tap OK to confirm
Your display can indicate if your heating system is due
for a service.
Note: Your heating contractor can set service intervals
(for burner hours run, for example).
A service message is generated when this value
is reached or exceeded.
Tap "Confirm". The footer shows
Calling up a service message
1. Tap in the footer. The service message appears in a list.
2. Notify your local heating contractor.
Note: If the service cannot be carried out until a later
date, the service message will be displayed again
the following Monday. This service message will
continued to be displayed until your service
contractor resets the service interval.
Note: After tapping the following will be displayed
if your heating system has several fault messages
simultaneously:
Tap "Service messages"
Service messages appear in yellow.
Scanning
.
25