Wiring Diagram - Master MH-600T-KFA User's Manual & Operating Instructions

NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE
Maintenance (Continued)
NOTE: Use only original equipment replacement parts. Use of
alternate or third party components will void any warranty and
may cause unsafe operating conditions.
- Stop heater (See OPERATION, page 6).
- If accessory pressure gauge is being used, remove pressure
gauge.
- Replace pressure gauge, and plug in end of filter cover.
NOTE: If heater does not ignite when heater is turned on, please
Pump Adjusting
turn AIR VENT SCREW counter clockwise to release air, then
Screw
turn OPERATION SWITCH back on.
Figure 14: Pump Pressure Adjustment

Wiring Diagram

Figure 15: Wiring Diagram for MH-600T-KFA
11
© 2014 Pinnacle Products International, Inc. Kerosene User's Manual