Assembly - Master MH-600T-KFA User's Manual & Operating Instructions

Wheel support frame
Wheels and Axle
Front and Rear Handle
Handle Frame
Screws, Nuts and Washers
Cotter Pins and Bushings
Wheels
Screws (L) Flat Washers (S)
Screws (S)
Nuts
Figure 3: Hardware Components
MH-600T-KFA
- Tools required: Medium phillips screw driver, open end or
adjustable wrench, needle nose pliers.
ASSEMBLING FRAME AND WHEELS
1. Slide axle through wheel support frame. Install wheel bushings,
flat washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from
support frame (Figure 2).
2. Place flat washers (L) and cotter pins on axle ends and bend
cotter pins with long nose pliers to secure.
© 2014 Pinnacle Products International, Inc.
Assembly (Continued)
Wheel Caps
Cord Wraps
Bushings
Flat Washers (L)
Cotter Pins Bushings
Cord Wraps
Front Handle
Wheel Support Frame
3. Place wheel cap on flat washers (L) and put wheel cap in flat
washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Align the holes on fuel tank
flange. Insert screws through handles (front and rear), fuel tank
flange, and wheel support frame as shown in Figure 3 and
attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
CAUTION
TO TANK.
5
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE
MH-600T-KFA
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Handle Frame
DO NOT OPERATE HEATER WITHOUT
SUPPORT FRAME FULLY ASSEMBLED
Kerosene User's Manual
Rear Handle
Axle