Chevrolet 1973 Monte Carlo Owner's Manual page 47

that jack base is level before
raising car.
4. When jacking the car, position
the jack so that jack hook is fully
inserted in lift slot of the bumper.
NOTE: Always use a smooth mo-
tion when raising or lowering car.
5. Insert jack handle in jack and
and raise car until wheel is just
off the ground.
6. Remove wheel nuts and wheel.
7. Install spare wheel and install
wheel nuts (with beveled end of
nut facing inward) until all are
finger tight.
8. Place jack control lever in
"down" position and lower wheel
until tire just touches ground.
Tighten wheel nuts, lower car
45
and remove jack. Carefully in-
stall hub cap or wheel cover.
9. Replace jack assembly and wheel
in luggage compartment.
When possible check inflation of
replacement tire to agree with tire
placard affixed to the left front door.
NOTE: Illustrated instructions on
jack operation and storage are also
provided on underside of trunk lid.