Changing The Floor-Tool Blades - Numatic TTB 4045/100 Owner's Instructions Manual

!
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED PRIOR TO ANY
The floor-tool
The TTB range is provided with the aluminium floor-tool shown.
The ETB range is provided with the Eco Range floor-tool.
To clean the floor-tool, remove securing-pin and disconnect the lifting strap and remove the floor-tool securing
pin pull-free the floor-tool from the rear of the machine.
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (see Fig.38), turn the floor-tool over and
separate the blade carrier from the body (see Fig.39).Peel away the blades from their locating lugs (see Fig.40) and
examine or renew as required.
Replacement is a reversal of the removal process.
Floor-tool overview
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4
Note:
The blades are designed to be reversible, thus extending their useful working life.
Changing the Floor Tool Blades
MAINTENANCE
Fig.39
1
2
3
4
5
15
Fig.38
Fig.40
!