Filling The Clean-Water Tank - Numatic TTB 4045/100 Owner's Instructions Manual

Filling the clean-water tank

The TTB / ETB Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single
fill.
Fig.21
The clear Dump hose at the rear of the machine can be used to see the level of the clean water.
Note:
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/
!
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig.22).
Numatic part (629044) Wet Floor sign
(available if required)
To fill the clean-water tank, use the 1 meter FLEXI
- FILL pipe from either a tap or hose pipe (Fig.21).
The large cap can also be unscrewed for filling
from a bucket or suitable container.
Fill the clean-water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
for UK information.
11
Machine Set-Up
Fig.22
!
!