Setting The Cleaning Controls - Numatic TTB 4045/100 Owner's Instructions Manual

To activate the machine from SLEEP MODE press either trigger once.
Hi / Lo speed can only be toggled when the machine is in STAND-BY MODE.
Water On / Off can only be toggled when in ACTIVE MODE.
Brush / Vac Switch
STAND-BY
Stage 1.
Stage 2.
Stage 3.
ACTIVEv
Stage 1.
Stage 2.
When the triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will
continue for 10 seconds (this is to clear any fluid residue in the hose).
The panel if unused will automatically enter SLEEP MODE after 60 seconds.
If the brush motor keeps overloading consider using a different type of brush.
Or move the transit wheels to obtain different brush pressures,
Heavy brush load decreases the available battery run time.
Fig.27
can be cycled in both STAND-BY and ACTIVE MODE.
Brush and Vac
Brush only
Vac only
Brush and Vac
Brush
Fig.28

Setting the cleaning controls

Brush overload.
The brush LED light will flash if the brush motor has been
overloaded (Fig.28).
Releasing the handle triggers will allow the machine to stop
and reset.
13