Cabin Doors; Windshield And Windows - Cirrus DESIGN SR22 Pilot Operating Handbook

Section 7
Systems Description
installed using the center seat belt. Three top tether anchors for the
child seats are located on the rear bulkhead.
To install a child seat:
1. Fasten lower seat attachments to bench seat:
a. LATCH Compliant Outboard Seat: Fasten lower seat
attachment to the outboard anchors in the bench seat.
b. Non-LATCH Compliant Center Seat: Using the center seat
belt, fasten lower seat attachments to the bench seat as
described by the manufacturer's instructions
2. Locate top tether pass-through - a narrow slit in the seat back
upholstery - near the top, outboard section of the seat back.
Do not route child seat top tether over or around seat back.
The top tether must be routed through the seat back pass-
through for the child seat to function properly.
3. Route child seat's top tether through the seat back pass-through.
4. Fasten top tether to rear bulkhead anchor.
5. Firmly tension
manufacturer's instructions.

Cabin Doors

Two large forward hinged doors allow crew and passengers to enter
and exit the cabin. The door handles engage latching pins in the door
frame receptacles at the upper aft and lower aft door perimeter. Gas
charged struts provide assistance in opening the doors and hold the
doors open against gusts. Front seat armrests are integrated with the
doors. A key lock in each door provides security. The cabin door keys
also fit the baggage compartment door lock. Separate keys are
provided for the fuel caps.

Windshield and Windows

The windshield and side windows are manufactured of acrylic. Use
only clean soft cloths and mild detergent to clean acrylic surfaces.
Refer to Section 8,
instructions.
7-30
• Caution •
the child seat
Windshield and Windows
straps according
for detailed cleaning
Cirrus Design
SR22
to the
P/N 13772-002
Reissue A